Installation and Operation User Guide
6 November-2007 Bulletin II-102051-EN • Revision B White or 2: neg (-)Brown: NCWhite: COMBlue: NOTo EAITo DC supply: ±20 to ±60 VDCBlue: 6Green: 5Re
Bulletin II-102051-EN • Revision B November-2007 7 The PDU provides DC power conversion, regulation, and distrib
8 November-2007 Bulletin II-102051-EN • Revision B .59!GREEN light indicates supply voltage is within specified range. DARK otherwis
Bulletin II-102051-EN • Revision B November-2007 9 -(The Power Cable is illustrated in Figure 7. Two color-coded or number-coded 18 –
10 November-2007 Bulletin II-102051-EN • Revision B Figure 9: Standard Bias Tee Harness Figure 10: Sector-split Bias Tee Harness 1 2)3
Bulletin II-102051-EN • Revision B November-2007 11 !!. Select the installation location. The PDU installs in a standar
12 November-2007 Bulletin II-102051-EN • Revision B 686=/0,>.+?If installing the PDU in a 23” rack, first attach the
Bulletin II-102051-EN • Revision B November-2007 13 % )*, %"-". %&-". . &
14 November-2007 Bulletin II-102051-EN • Revision B 6#+$,Connect the Bias Tee Harness to the DC Output connector and tigh
Bulletin II-102051-EN • Revision B November-2007 15 For all outputs in use, set the DC Output DIP switches to ENABLE (up) and the TMA Alarm DIP swit
16 November-2007 Bulletin II-102051-EN • Revision B • For all outputs where DC Output DIP switches are ENABLED and TMA Alarm DIP switches are ENABL
Bulletin II-102051-EN • Revision B November-2007 17 " Before operating, ensure all parts of the TMA system are installed and all con
18 November-2007 Bulletin II-102051-EN • Revision B indications will clear once the problem is corrected. " 5.55,,Each output is
Bulletin II-102051-EN • Revision B November-2007 19 #!$%Because the PDU supplies and monitors the entire TMA system, all system compo
20 November-2007 Bulletin II-102051-EN • Revision B +./,If DC passes through a diplexer (crossband coupler) at the base or tower top: •
Bulletin II-102051-EN • Revision B November-2007 21 '( $! #!A functional block diagram of the P
22 November-2007 Bulletin II-102051-EN • Revision B Andrew TMAs are equipped with internal fault monitoring and will raise or lower their current co
Bulletin II-102051-EN • Revision B November-2007 23 5 +*2$ #%/. & ).: ):2 & )2:A 3 )A:
24 November-2007 Bulletin II-102051-EN • Revision B '#( #, The PDU and its accessories are eac
Bulletin II-102051-EN • Revision B November-2007 25 # #+$, 5)- !" . 3&+ 3&67.."
Bulletin II-102051-EN • Revision B November-2007 iii
26 November-2007 Bulletin II-102051-EN • Revision B '( )#( !Beginning with revision 02, the Mul
iv November-2007 Bulletin II-102051-EN • Revision B *++$+,- !" # #"$%&"
Bulletin II-102051-EN • Revision B November-2007 1 This manual provides a complete des
2 November-2007 Bulletin II-102051-EN • Revision B All operations relating to the installation of the PDU must be executed in accordance w
Bulletin II-102051-EN • Revision B November-2007 3 A typical TMA system consists of TMAs, Bias Tees, and PDU with accessories.
4 November-2007 Bulletin II-102051-EN • Revision B Bias Tees are installed on the antenna ports of one of the base stations. The diplexers must pass
Bulletin II-102051-EN • Revision B November-2007 5 #12+./0Figure 3 shows a TMA system with Andrew OneBase™ TMAs and separa
Comments to this Manuals